Announcement

Collapse
No announcement yet.

scoring pegs

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • ballouj
    replied
    Re: scoring pegs

    How did you determine the heights? The PVC Cutlength is specified but no where do I see a drawing showing the center point of the pegs. The PVC can go into the T at different depths depending on how hard you push.
    Last edited by ballouj; 01-15-2011, 11:21 AM.

    Leave a comment:


  • Paul E. Lathrop
    replied
    Re: scoring pegs

    There are two different sets of heights. The heights of the pegs on the sides of each set of 3 are 30-30-30. The center peg height is 8 inches higher than the others (ie 38-38-38). These figures to my knowledge are measured center to center but the wording got us confused for a bit as well.

    Leave a comment:


  • echos
    started a topic scoring pegs

    scoring pegs

    Can someone tell us how high each of the scoring pegs are?
Working...
X