If this is your first visit, be sure to check out the FAQ by clicking the link above. You will have to register before you can post by clicking on the Registration link above. To start viewing messages, select the forum that you want to visit from the selection below.
Worked with 3 rookie teams and none would access the imaging flash drive when hitting F12 at power up per instructions. Since Win 8 was already installed, went ahead with both LabView installs. Was able to update firmware and image roboRIO and compile and download test program via USB. Will the teams need to do something else or are they good to go as is?
Bob Koehl
Michigan Engineering Zone
If they're up and running they are fine. If the menu didn't show up at all, then it was disabled, I'll be adding the instructions to enable it to the ScreenSteps. If the boot menu showed, but the USB drive didn't show on it the USB key was somehow corrupted.
FYI: no boot menu showed.
What Windows version will be installed using the flash drive?
Will there be potential issues with the wifi or does the installed wifi work OK?
Bob Koehl
The MEZ
The Image contains Windows 7. We did not test with the factory installed driver as we were under the impression that the computers were going to be shipped without an OS.
The rookie team that we are assisting has windows 10 already loaded on their computer (Acer E11). We have tried the recommended solution, including the video without success. We get to the boot menu just like in the video, however, being able to boot from the USB is not an option just like on the video.
Hi again! Sorry for the delay. I believe I have found the likely cause of the issue. There is an additional setting in the BIOS on the Boot tab that likely needs to be set.
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment