Announcement

Collapse
No announcement yet.

Panel Signal Device?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Dr_De
    replied
    Re: Panel Signal Device?

    http://forums.usfirst.org/showthread.php?t=18677

    See my most recent post in this thread; it explains everything about the RSL wiring. You could use the header mate we discuss or the method we ended up using.

    Please search before you post

    Leave a comment:


  • owlman
    replied
    Re: Panel Signal Device?

    remember to strip the wires-if you dont the light wont work. We made that mistake. Ha.

    Leave a comment:


  • 2011FRC3777
    replied
    Re: Panel Signal Device?

    There was no jumper included in the kit; any piece of wire will work fine. When you're cutting one end off of one of the solenoid cable, just cut off another small piece and use that for the jumper.

    Leave a comment:


  • kuriharak93
    replied
    Re: Panel Signal Device?

    Thank you for your reply. We have the cable we need to connect it to the robot, but I think we are missing the jumper that connects to the light. Did it come already attached? Or was it in one of the other bags?
    Thanks,
    Kealakehe Robotics

    Leave a comment:


  • steinra
    replied
    Re: Panel Signal Device?

    If you are thinking you are missing a cable, you probably are not. In most cases we use the Solenoid cable as the base to connect to our light. It has the 2 wire (red and white) with a 2 pin female header at each end. This will fit the header on the digital side car where it is to plug in. We cut one of the headers off and then wire to the light. There is a jumper to add as well. Look in the wiring guide, I believe it is covered there.

    Randy

    Leave a comment:


  • kuriharak93
    started a topic Panel Signal Device?

    Panel Signal Device?

    Our Signal Light did not come with any way for us to wire it to our robot. Is there a way for us to get a new one? I tried searching on the Rockwell Automation website but I couldn't seem to find it. Can anyone help?
    Thanks,
    Kealakehe Robotics
Working...
X